Mon-Fri from 09:00 to 18:00,
A detailed buying guide: how to choose an air hose and quick couplers.
This section covers air hoses — polyurethane, rubber, PVC and hybrid, recoil hoses and hose reels — as well as quick couplers, fittings and adapters. They carry compressed air from the compressor to screwdrivers, impact wrenches, spray guns, blow guns and other air tools in workshops, car service centres, building sites and home garages. A correctly chosen hose and coupler reduce pressure loss and let you swap tools quickly without spanners.
Straight hoses suit fixed lines and long distances, recoil hoses of 5–15 m suit compact work at the bench, and reels keep the hose tidy. A quick coupler consists of a socket and a plug, which must belong to the same system. See what pneumatic tools are and how they work.
A 6 mm inner diameter is enough for blow guns and light tools, 8 mm suits most tools, and 10 mm or more is for 1/2" impact wrenches, sanders and long lines. A narrow hose restricts flow and the tool loses power. Read how to calculate compressor air delivery.
Polyurethane hoses are light and flexible, rubber hoses are heavier but stay supple in the cold and resist oil and sparks, while PVC is cheap but stiffens in winter. Hybrid hoses combine flexibility and toughness. For storage, see how to store and maintain an air compressor.
Hose and coupler working pressure is usually 10–20 bar, with burst pressure about three times higher. It must exceed the maximum compressor pressure, which is usually 8–10 bar. Read how to choose compressor working pressure.
Typical lengths are 5, 10, 15, 20 and 30 m: the longer the hose, the greater the pressure drop, especially with a small diameter. For long lines choose a larger diameter and a compressor with spare air delivery. See how to choose an air compressor.
The most common systems are EURO, ORION and RAPID, which are not interchangeable, so use one standard throughout the workshop. Fittings have 1/4", 3/8" or 1/2" male or female threads or a hose barb. For replacement parts, read how to choose spare parts for pneumatic and hydraulic tools.
Secure hoses with clamps, choose safety sockets that vent pressure first, and never disconnect a pressurised hose while holding it by hand. Replace a damaged, cracked or bulging hose immediately. Read how to use pneumatic tools safely and how to use an air compressor safely.
Use fittings with the same thread to install a filter, regulator and lubricator in the line, and keep a separate oil-free hose for painting. Condensate collects at low points, so blow out and drain the hose periodically. See how to prepare compressed air: condensate, filters, regulators, and lubricators.
At ToolsArmenia you can compare air hoses and quick couplers by material, inner diameter, length, working pressure and coupler standard and choose the right solution for your compressor and tools.
There are no products to list in this category.
