Mon-Fri from 09:00 to 18:00,
A detailed buying guide: how to choose a square and ruler.
Squares and rulers check right angles and measure short distances during marking out. This section is for carpentry and engineering squares, steel rulers, bevels, protractors and calipers. General guide: how to choose hand measuring, marking and layout tools.
A carpenter’s square has a wide stock, an engineer’s square a precise 90°, and a sliding bevel sets any angle.
Choose the length of the ruler or square (150-1000 mm) to suit the workpieces.
An engraved scale does not wear off, and a caliper measures to 0.1-0.02 mm.
Stainless steel and aluminium do not bend or rust. Read hand tool materials, hardness, coatings and ergonomics.
Do not use a square as a lever or hammer. Read how to use hand tools safely.
Store tools hanging or in a case so they do not bend. Read how to maintain, store and organize hand tools.
At ToolsArmenia you can choose squares and rulers by type, length and accuracy.
There are no products to list in this category.
